Hi,


thank you for your message. I just found it now in our inbox.


About bearing, not worry about.


Nothing is broken , it is just comming out and is normal if the axle is not pushed straight inside. 


Your grinder have very close tollerance so you just dislog the bearing from place that was pushed and fixed in place.


You just clean the case of the bearing , clean please the hole in the metal upper bolt and push the bearing back straight. 


You can use 2 points of glue to fix it but as mentioned, tollerance are close , it will hold in place without to glue also.


When it comes out from now , you just can clean it and put it back. It is nothing negative and more a positive. We use same here in our privat kitchen. :-) 


Keep in touch and welcome in the Kinu family !

판단은 알아서...